Drive optionsDrive options
Depending on the configuration, this server supports SAS, SATA, NVMe, and M.2 drives. For more information on drive support, see the
product QuickSpecs.
When adding hard drives to the server, observe the following general guidelines:
The system automatically sets all device numbers.
For drive numbering, see Drive bay numbering.
If using only one hard drive, install it in the bay with the lowest device number.
To provide the greatest storage space efficiency, group identical capacity drives into the same drive array.
The NVMe SSD is a PCIe bus device. Do not remove NVMe drives without allowing the device to cease activity. Removing the drive
while active can cause data loss.
SubtopicsSubtopics
Drive guidelinesDrive guidelines
Installing a hot-plug SAS, SATA or NVMe driveInstalling a hot-plug SAS, SATA or NVMe drive
Installing an M.2 driveInstalling an M.2 drive
To Next Page
Loading...
