Installing a high performance heatsinkInstalling a high performance heatsink
PrerequisitesPrerequisites
CAUTION:CAUTION: Installing a high performance heatsink requires the installation of a processor assembly onto the heatsink. To
avoid damage to server or components, do not remove or install the processor assembly when installing or replacing
other heatsinks.
To determine when a high performance heatsink should be installed in the server, see the server QuickSpecs
(https://www.hpe.com/info/qshttps://www.hpe.com/info/qs).
Before installing this option, be sure that you have the following:
The components included with the hardware option kit
T-30 Torx screwdriver
ProcedureProcedure
1. Observe the following alerts.
CAUTION:CAUTION: The processor assembly must be removed and replaced as a unit. Do not remove the processor from the
carrier.
CAUTION:CAUTION: When handling the heatsink, always hold it along the top and bottom of the fins. Holding it from the sides
can damage the fins.
CAUTION:CAUTION: THE CONTACTS ARE VERY FRAGILE AND EASILY DAMAGED. THE CONTACTS ARE VERY FRAGILE AND EASILY DAMAGED. To avoid damage to the socket or
processor, do not touch the contacts.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
a. Extending the server from the rack.
b. Removing the server from the rack.
5. Remove the access panel.
6. Observe the following cautions.
CAUTION:CAUTION: Be sure to loosen each heatsink nut in the order indicated. Otherwise, damage might occur to the
heatsink or processor.
CAUTION:CAUTION: Install the processor heatsink assembly as soon as possible after removing it. Do not leave the processor
socket unpopulated for extended periods of time.
7. Remove the existing processor heatsink assembly:
a. Allow the heatsink to cool.
b. Using a T-30 Torx screwdriver, loosen the heatsink nuts.
To Next Page
Loading...
