Installing an M.2 driveInstalling an M.2 drive
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have the following items available:
The components included with the hardware option kit
T-10 Torx screwdriver
About this taskAbout this task
This procedure is for replacing M.2 drives located on an expansion card, riser, or the system board only. Do not use this procedure to
replace uFF drives.
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
4. Remove the access panel .
5. Remove the riser cage.
6. Install the drive.
ResultsResults
The installation is complete.
To Next Page
Loading...
