3. Install the drive.
LFF drive
SFF drive
4. Determine the status of the drive from the drive LED definitions .
5. To configure drive arrays, see the following documentation for detailed instructions:
HPE SR Gen10 Plus Software RAID User Guide at https://www.hpe.com/support/SSC-SRGen10Plus-ughttps://www.hpe.com/support/SSC-SRGen10Plus-ug
HPE SmartRAID SR Gen10 Plus Controller User Guide at https://www.hpe.com/info/SmartRAID-Gen10Plus-UGhttps://www.hpe.com/info/SmartRAID-Gen10Plus-UG
HPE MegaRAID MR Gen10 Plus Controller User Guide at https://www.hpe.com/info/MegaRAID-Gen10Plus-UGhttps://www.hpe.com/info/MegaRAID-Gen10Plus-UG
To Next Page
Loading...
