HPE ProLiant DL380 Gen10 Plus - Installing the TPM Board and Cover

Installing the TPM board and coverInstalling the TPM board and cover
ProcedureProcedure
1. Observe the following alerts:
CAUTION:CAUTION: If the TPM is removed from the original server and powered up on a different server, data stored in the
TPM including keys will be erased.
CAUTION:CAUTION: The TPM is keyed to install only in the orientation shown. Any attempt to install the TPM in a different
orientation might result in damage to the TPM or system board.
2. Install the TPM board:
a. Locate the TPM connector on the system board. See the server hood label for the exact location.
b. Align the TPM board with the key on the connector, and then install the TPM board. To seat the board, press the TPM board
firmly into the connector.
3. Install the TPM cover:
a. Align the pins on the cover with the openings on the system board.
b. Press straight down on the middle of the cover until the alignment pins are seated into the holes.
Installing the TPM board and cover 203