HPE ProLiant DL560 Gen10 - Replacing Internal Components

10. Install the access panel.
11. Install the server into the rack.
12. Connect each power cord to the server.
13. Connect each power cord to the power source.
14. Power up the server.
Removing and replacing a DIMM
CAUTION: Failure to properly handle DIMMs can damage the DIMM components and the system board connector. For
more information, see the DIMM handling guidelines in the troubleshooting guide for your product on the Hewlett
Packard Enterprise website:
• HPE ProLiant Gen10 (
https://www.hpe.com/info/gen10-troubleshooting)
• HPE Synergy (
https://www.hpe.com/info/synergy-troubleshooting)
For specific DIMM population information, see the DIMM population guidelines on the Hewlett Packard Enterprise website
(http://www.hpe.com/docs/memory-population-rules).
To identify the DIMMs installed in the server, see DIMM slot locations.
Procedure
1.
Power down the server.
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Do one of the following:
• Extend the server from the rack (
Extend the server from the rack).
• Remove the server from the rack (Removing the server from the rack).
4.
Remove the access panel (Removing the access panel).
CAUTION: Do not operate the server for long periods with the access panel open or removed. Operating the server
in this manner results in improper airflow and improper cooling that can lead to thermal damage.
5. If installed, do the following:
a. Remove the air bale (Removing and replacing the air bale).
b. Remove the processor mezzanine tray (
Removing and replacing the processor mezzanine tray).
c. Remove the CPU Mezzanine UPI performance kit (Removing and replacing the CPU Mezzanine UPI performance kit).
6. Remove the DIMM.
Removal and replacement procedures
57