CAUTION: Do not operate the server for long periods with the access panel open or removed. Operating the server
in this manner results in improper airflow and improper cooling that can lead to thermal damage.
5. Disconnect the SAS cables.
6. Remove the PCIe riser cage (
Removing and replacing a PCIe riser cage).
7. Disconnect the controller backup power cable from the controller backup power connector on the riser board.
8.
Remove the type-p controller.
To replace the component, reverse the removal procedure.
Removing and replacing an intrusion detection switch
Procedure
1.
Power down the server.
2. Remove all power:
Removal and replacement procedures
91
To Next Page
Loading...
