a. Remove the air bale (Removing and replacing the air bale).
b. Remove the processor mezzanine tray (Removing and replacing the processor mezzanine tray).
c. Remove the CPU Mezzanine UPI performance kit (Removing and replacing the CPU Mezzanine UPI performance kit).
7. Disconnect any cables connected to the controller.
8. Remove the controller.
To replace the component, reverse the removal procedure.
Removing and replacing a type-p controller
CAUTION: To prevent damage to the server or expansion boards, power down the server and remove all AC power
cords before removing or installing the PCIe riser cage.
Procedure
1.
Power down the server.
2.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
• Extend the server from the rack (Extend the server from the rack).
• Remove the server from the rack (Removing the server from the rack).
4. Remove the access panel (
Removing the access panel).
90
Removal and replacement procedures
To Next Page
Loading...
