To replace the component, reverse the removal procedure.
Removing and replacing a processor
Before performing this procedure, Hewlett Packard Enterprise recommends identifying the processor, heatsink, and socket
components.
IMPORTANT: Existing HPE ProLiant and HPE Synergy Gen10 server products containing first-generation Intel Xeon
Scalable processors may not be upgraded to second-generation Intel Xeon Scalable processors at this time.
For more information, see the product QuickSpecs on the Hewlett Packard Enterprise website (
http://www.hpe.com/
info/qs).
Procedure
1.
Observe the following alerts.
CAUTION: When handling the heatsink, always hold it along the top and bottom of the fins. Holding it from the
sides can damage the fins.
CAUTION: To avoid damage to the processor or system board, only authorized personnel should attempt to
replace or install the processor in this server.
CAUTION: To prevent possible server malfunction and damage to the equipment, multiprocessor configurations
must contain processors with the same part number.
CAUTION: If installing a processor with a faster speed, update the system ROM before installing the processor.
To download firmware and view installation instructions, see the Hewlett Packard Enterprise Support Center
website.
Removal and replacement procedures 53
To Next Page
Loading...
