a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
• Extend the server from the rack (Extend the server from the rack).
• Remove the server from the rack (Removing the server from the rack).
4. Remove the access panel (Removing the access panel).
CAUTION: Do not operate the server for long periods with the access panel open or removed. Operating the server
in this manner results in improper airflow and improper cooling that can lead to thermal damage.
5. Disconnect all cables attached to the expansion boards in the PCIe riser cage.
6. Remove the PCIe riser cage (Removing and replacing a PCIe riser cage).
7. Remove the auxiliary card (
Removing and replacing an expansion board).
8.
Disconnect the cables to the auxiliary card:
a.
Open the retention clip and slide it away from the connectors.
b.
Gently pull up the top corner of the cable latch door.
c.
Disconnect the card cables.
9.
Remove the adapter (
Removing and replacing an expansion board).
10.
Disconnect the cables to the adapter.
To replace the component:
1.
Thread the adapter end of the auxiliary card cables through one of the retention clips provided with the installation kit.
2. Open the cable latch door, connect the auxiliary card cables to the adapter ports so that the golden side of the cable
connector is on the top, and then close the cable latch door.
Removal and replacement procedures
75
To Next Page
Loading...
