HPE ProLiant MicroServer Gen10 Plus User Manual

Prerequisites
Before you perform this procedure, make sure that you have the following items available:
• Isopropyl alcohol wipe
• Antislip rubber strips
Procedure
1. Use an isopropyl alcohol wipe to clean the divots on the side of the server. Allow the alcohol to evaporate before
continuing.
2.
Peel o the protective liner from the rubber strips.
3.
Attach the strips onto the divots. To ensure proper adhesion, press along the entire strip.
4.
Position the server in a vertical orientation.
Setup
31

HPE ProLiant MicroServer Gen10 Plus Specifications

General

Processor Cores	4
Memory Slots	2
Network	2 x 1GbE ports
Processor	Intel Xeon E-2224
Processor Base Frequency	3.4 GHz
Storage	4 LFF SATA HDD bays
Storage Controller	Embedded SATA controller
Expansion Slots	1 PCIe 3.0 x16 slot
Form Factor	Ultra-micro tower
Remote Management	HPE iLO 5
Operating System Support	Microsoft Windows Server, Red Hat Enterprise Linux, VMware ESXi
Dimensions	22.97 x 24.5 x 24.5 cm (8.98 x 9.65 x 9.65 in)