EasyManuals Logo

HPE ProLiant MicroServer Gen10 Plus User Manual

HPE ProLiant MicroServer Gen10 Plus
89 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
Operations
This chapter describes the hardware operations carried out prior to and after installing or removing a hardware option, or
performing a server maintenance or troubleshooting procedure.
Before performing these hardware operations, review and observe the server warnings and cautions.
Power up the server
To power up the server, use one of the following methods:
Press the Power On/Standby button.
Use the virtual power button through iLO.
Power down the server
Before powering down the server for any upgrade or maintenance procedures, perform a backup of critical server data
and programs.
IMPORTANT: When the server is in standby mode, auxiliary power is still being provided to the system.
To power down the server, use one of the following methods:
Press and release the Power On/Standby button.
This method initiates a controlled shutdown of applications and the OS before the server enters standby mode.
Press and hold the Power On/Standby button for more than 4 seconds to force the server to enter standby mode.
This method forces the server to enter standby mode without properly exiting applications and the OS. If an
application stops responding, you can use this method to force a shutdown.
Use a virtual power button selection through iLO 5.
This method initiates a controlled remote shutdown of applications and the OS before the server enters standby
mode.
Before proceeding, verify that the server is in standby mode by observing that the system power LED is amber.
Removing the front bezel
To access the drive bays, remove the front bezel.
Procedure
1. Power down the server.
2. Disconnect the power cord from the AC source.
3. Remove the power adapter cord from the power cord clip, and then disconnect the power adapter from the server.
4. Disconnect all peripheral cables from the server.
5. If the server is in a vertical orientation, position the server in a horizontal orientation.
Operations
15

Table of Contents

Other manuals for HPE ProLiant MicroServer Gen10 Plus

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HPE ProLiant MicroServer Gen10 Plus and is the answer not in the manual?

HPE ProLiant MicroServer Gen10 Plus Specifications

General IconGeneral
Processor Cores4
Memory Slots2
Network2 x 1GbE ports
ProcessorIntel Xeon E-2224
Processor Base Frequency3.4 GHz
Storage4 LFF SATA HDD bays
Storage ControllerEmbedded SATA controller
Expansion Slots1 PCIe 3.0 x16 slot
Form FactorUltra-micro tower
Remote ManagementHPE iLO 5
Operating System SupportMicrosoft Windows Server, Red Hat Enterprise Linux, VMware ESXi
Dimensions22.97 x 24.5 x 24.5 cm (8.98 x 9.65 x 9.65 in)

Related product manuals