Prerequisites
Embedded UEFI Shell is set to Enabled.
Procedure
1. From the System Utilities screen, select Embedded Applications > Embedded UEFI Shell.
The Embedded UEFI Shell screen appears.
2. Press any key to acknowledge that you are physically present.
This step ensures that certain features, such as disabling Secure Boot or managing the Secure Boot certificates using
third-party UEFI tools, are not restricted.
3. If an administrator password is set, enter it at the prompt and press Enter.
The Shell> prompt appears.
4. Enter the commands required to complete your task.
5. Enter the exit command to exit the Shell.
HPE Smart Storage Administrator
HPE SSA is the main tool for configuring arrays on HPE Smart Array SR controllers. It exists in three interface formats: the
HPE SSA GUI, the HPE SSA CLI, and HPE SSA Scripting. All formats provide support for configuration tasks. Some of the
advanced tasks are available in only one format.
The diagnostic features in HPE SSA are also available in the standalone software HPE Smart Storage Administrator
Diagnostics Utility CLI.
During the initial provisioning of the server or compute module, an array is required to be configured before the operating
system can be installed. You can configure the array using SSA.
HPE SSA is accessible both
oline (either through HPE Intelligent Provisioning or as a standalone bootable ISO image)
and online:
• Accessing HPE SSA in the oline environment
IMPORTANT: If you are updating an existing server in an
oline environment, obtain the latest version of HPE
SSA through Service Pack for ProLiant before performing configuration procedures.
Using one of multiple methods, you can run HPE SSA before launching the host operating system. In oline mode,
users can configure or maintain detected and supported devices, such as optional Smart Array controllers and
integrated Smart Array controllers. Some HPE SSA features are only available in the
oline environment, such as
setting the boot controller and boot volume.
• Accessing HPE SSA in the online environment
This method requires an administrator to download the HPE SSA executables and install them. You can run HPE SSA
online after launching the host operating system.
For more information, see HPE Smart Array SR Gen10 Configuration Guide at the Hewlett Packard Enterprise website.
HPE InfoSight for servers
The HPE InfoSight portal is a secure web interface hosted by HPE that allows you to monitor supported devices through a
graphical interface.
72
Software and configuration utilities
To Next Page
Loading...
Need help?
General
