To Next Page

To Previous Page

6. Remove the chassis cover.

7. Remove the system board assembly.

8. Locate the battery on the system board.

9. Remove the system battery:

a. Use a small flat-bladed, nonconductive tool to press the battery latch (callout 1).

b. Remove the system battery from the socket (callout 2).

10.

Install the system battery:

With the side of the battery showing the "+" sign facing up, insert the battery into the socket (callout 1).

Press the system battery down until it clicks into place (callout 2).

11. Install the server board assembly.

12.

Install the chassis cover.

13. If removed, install the security padlock and/or the Kensington security lock.

For more information, see the lock documentation.

14. Connect all peripheral cables to the server.

System battery replacement

Other manuals for HPE ProLiant MicroServer Gen10 Plus

Questions and Answers:

Need help?

Do you have a question about the HPE ProLiant MicroServer Gen10 Plus and is the answer not in the manual?

General

Processor Cores	4
Memory Slots	2
Network	2 x 1GbE ports
Processor	Intel Xeon E-2224
Processor Base Frequency	3.4 GHz
Storage	4 LFF SATA HDD bays
Storage Controller	Embedded SATA controller
Expansion Slots	1 PCIe 3.0 x16 slot
Form Factor	Ultra-micro tower
Remote Management	HPE iLO 5
Operating System Support	Microsoft Windows Server, Red Hat Enterprise Linux, VMware ESXi
Dimensions	22.97 x 24.5 x 24.5 cm (8.98 x 9.65 x 9.65 in)