ResultsResults
To replace the component, reverse the removal procedure.
Drive replacementDrive replacement
SubtopicsSubtopics
Removing and replacing a non-hot-plug LFF SATA driveRemoving and replacing a non-hot-plug LFF SATA drive
Removing and replacing a hot-plug LFF SAS or SATA driveRemoving and replacing a hot-plug LFF SAS or SATA drive
Removing and replacing a hot-plug SFF SAS or SATA driveRemoving and replacing a hot-plug SFF SAS or SATA drive
Removing and replacing a non-hot-plug LFF SATA driveRemoving and replacing a non-hot-plug LFF SATA drive
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
About this taskAbout this task
CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
ProcedureProcedure
1. Back up all server data on the drive .
2. Remove the front bezel.
3. Power down the server.
To Next Page
Loading...
