d. Place the heatsink on a flat work surface with its contact side facing upward.
Installing the heatsinkInstalling the heatsink
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have the following items available:
T-15 Torx screwdriver
Alcohol wipe
About this taskAbout this task
CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
ProcedureProcedure
1. Use an alcohol wipe to remove the existing thermal grease from the processor.
Allow the alcohol to evaporate before continuing.
2. Remove the thermal interface protective cover from the new heatsink.
To Next Page
Loading...
