To replace the component, reverse the removal procedure.
Drive backplane replacementDrive backplane replacement
SubtopicsSubtopics
Removing and replacing the 4 LFF drive backplaneRemoving and replacing the 4 LFF drive backplane
Removing and replacing the 8 SFF drive backplaneRemoving and replacing the 8 SFF drive backplane
Removing and replacing the 4 LFF drive backplaneRemoving and replacing the 4 LFF drive backplane
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
About this taskAbout this task
CAUTION:CAUTION:
Before replacing a DIMM, backplane, expansion card, riser board, or other similar PCA components due to a perceived
hardware error, make sure first that the component is firmly seated in the slot.
When installing the replacement component:
Observe antistatic precautions.
Handle the PCA only along the edges.
Do not touch the components and connectors on the PCA.
Do not bend or flex the PCA.
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode, place the server on a flat, level surface with the access panel facing up.
To Next Page
Loading...
