ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing the serial port cableRemoving and replacing the serial port cable
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a hex screwdriver available.
About this taskAbout this task
CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode, place the server on a flat, level surface with the access panel facing up.
To Next Page
Loading...
