Media device replacementMedia device replacement
SubtopicsSubtopics
Removing and replacing a SAS LTO tape driveRemoving and replacing a SAS LTO tape drive
Removing and replacing a USB RDX docking stationRemoving and replacing a USB RDX docking station
Removing and replacing an optical driveRemoving and replacing an optical drive
Removing and replacing a SAS LTO tape driveRemoving and replacing a SAS LTO tape drive
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
About this taskAbout this task
CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
CAUTION:CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays are populated with
either a component or a blank.
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode, place the server on a flat, level surface with the access panel facing up.
To Next Page
Loading...
