Removing and replacing the serial port blankRemoving and replacing the serial port blank
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a spudger or any small prying tool available.
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Remove the serial port blank:
a. Use a plastic spudger to pry the blank from the rear panel (callout 1).
b. Remove the blank (callout 2).
ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing the iLO dedicated network port blankRemoving and replacing the iLO dedicated network port blank
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a spudger or any small prying tool available.
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Remove the iLO dedicated network port blank:
To Next Page
Loading...
