HPE STOREONCE 5500

NOTE:
Note the output at command completion. It will advise if you need a system reboot or a cold reboot to
install the new firmware revision successfully.
7. After power-up, it is necessary to rewrite warranty serial numbers into BIOS. Contact HPE Support for
assistance in rewriting warranty serial numbers.
RBSU settings
Change the RBSU settings, as shown in the following table.
Table 5: RBSU settings for StoreOnce Systems
Top Menu Item Sub Menu 1 Sub Menu 2 Current Default
State
Change To
Boot Options Boot Mode UEFI Mode Legacy BIOS Mode
Power Management
Options
HP Power Profile Balanced Power
and Performance
Maximum
Performance
Advanced Options Advanced System
ROM Options
Product ID 794753-B21
Date and Time Time (hh:mm:ss) As appropriate
Date and Time Time Zone UTC-07:00,
Mountain Time (US
& Canada)
UTC-00:00,
Greenwich Mean
Time, Dublin,
London
Performance
Options
Advanced
Performance Tuning
Options
Node Interleaving Disabled Enabled
Advanced Options Thermal
Configuration
Optimal Cooling Increased Cooling
BIOS Serial
Console & EMS
BIOS Serial
Console Port
Auto Physical
USB Options Embedded User
Partition
Disabled Only if 'enabled'
Disabled
iLO4 settings
Select the DNS/DHCP option and toggle DHCP Enable to OFF.
If DHCP is set to OFF, select NIC and TCP/IP and configure the network static IP addresses
RBSU settings 23