HPE STOREONCE 5500

Procedure
1. Disconnect the FC or 10GbE cable and lift the retaining clip so that you can slide the SFP carefully out of
the enclosure.
2. Remove the replacement SFP module from its protective packaging.
CAUTION:
When handling the SFP, do not touch the gold contact leads to prevent damage.
3. Carefully slide the replacement SFP into the enclosure until fully seated, close the retaining clip to secure it
in place.
NOTE:
Make sure that you use the correct SFP module—for a 10 GbE network port, an 8 Gb FC, or a 16 Gb
FC port, as appropriate.
4. Place the failed SFP into the packaging for return to HPE.
5. Reconnect the FC or 10GbE network cable to the SFP and verify that the link status LED is correct.
30 Replacing Optional Hardware