HUAWEI TE80 Videoconferencing Endpoint
Administrator Guide
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
packet loss is detected, the endpoint can
dynamically adjust bandwidth to recover
stable conference quality within 1
minute.
running within normal
parameters, select this
parameter.
reserved
presentation
bandwidth
Disable this parameter if your site is not
going to send or receive presentations
during a conference and the Received
value for Presentation bandwidth
[frame rate] is not -.
If this parameter is disabled, the
Received value for Presentation
bandwidth [frame rate] restores to -
when you rejoin the conference.
NOTE
To view the Presentation bandwidth
[frame rate] value, choose Advanced >
Diagnostics > Status > Conference.
The default value is Enable.
Specifies the protocol that IP sites
preferentially use.
When Line type is set to Auto for IP
sites, your endpoint uses this protocol to
call the IP sites.
The default value is H.323.
Specifies whether to perform HD
encoding and decoding to improve face
recognition video quality.
You can increase the video sharpness by
enabling this parameter in low
bandwidths.
The default value is Disable.
Site called
during startup
Specifies the site that your endpoint
automatically calls when it starts.
None: The endpoint does not call any
sites.
Select site from address book: The
endpoint displays the address book
screen from which you can specify
the site you want your endpoint to
call after its startup.
You can proceed to set Call times only
after you set this parameter.
The default value is None.
Specifies the maximum number of
attempts your endpoint calls a specified
site after startup.
The default value is 1.
The maximum value is 10.
If you set this parameter to
0, your endpoint does not
call the specified site after
startup.
To Next Page
Loading...
Need help?
General
