HUAWEI TE80 Videoconferencing Endpoint
Administrator Guide
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Network
About This Chapter
This chapter describes the hardware connection to network devices and the settings on
relevant screens required when the endpoint is used in different communication networks.
3.1 Connecting to an IP LAN Network
To implement video communication over an IP local area network (LAN), you must connect
the endpoint to the IP LAN.
3.2 Connecting to a 4E1 Network
Only the TE80 supports 4E1 functions. To implement video communication over a 4E1-line
dedicated network, you must connect the TE80 to the network.
3.1 Connecting to an IP LAN Network
To implement video communication over an IP local area network (LAN), you must connect
the endpoint to the IP LAN.
To connect to an IP LAN, use an IP network cable to connect the LAN 1 port on the
endpoint's rear panel to the network port on a LAN device.
3.1.1 Checking Status Indicators of the LAN Port
The status indicators on the LAN port can quickly provide information about the current
network connection.
There are two indicators working together to indicate the network connection, as shown in
Table 3-2.
Table 3-1 LAN status indicators of TE80
The orange indicator blinks once
at a time.
The LAN port is in 10 M network port mode.
The orange indicator blinks twice
The LAN port is in 100 M network port mode.
To Next Page
Loading...
Need help?
General
