HUAWEI TE80 Videoconferencing Endpoint
Administrator Guide
2 Basic Configuration and Verification
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Verification Result
This example assumes that a video source is connected to the 1 MAIN IN port on the endpoint.
If the video delivered through the 1 MAIN IN port is correctly displayed on the display device
after you select 1 MAIN IN, the video input and output of the endpoint are correct.
2.4 Power Management
The endpoint supports sleep mode. You can set its sleep time and automatic startup and
shutdown time.
To reduce power consumption, the endpoint can be configured to enter sleep mode after it has
been in the idle state for a defined period of time.
Procedure
Step 1 Choose Advanced > Settings > General > Power supply. Set the sleep and automatic startup
and shutdown parameters described in Table 2-4.
Table 2-4 Sleep and automatic startup and shutdown parameters
Specifies whether the endpoint
can be powered off.
If you disable this parameter,
you can only restart the endpoint
or place it in sleep mode by
pressing on the remote
control.
The default value is Enable.
Specifies the period after which
the endpoint enters sleep mode if
you do not perform any
operations.
If you set this parameter to
Never, the endpoint will never
automatically enter sleep mode.
The default value is After 10
min.
Specifies whether you can
remotely wake up a standby or
sleeping endpoint by sending
Wake on LAN (WOL) messages.
NOTE
A standby endpoint indicates that
the power switch on the endpoint's
rear panel is in the ON position and
that the endpoint is turned off by
pressing the power key on the
remote control.
This parameter is not selected by
default.
Specifies whether the endpoint
automatically powers on at the
This parameter is not selected by
default.
To Next Page
Loading...
Need help?
General
