HUAWEI TE80 Videoconferencing Endpoint
Administrator Guide
4 Display Device and Camera
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
noise but detail may also be lost.
Set output
resolution
automaticall
y
Specifies whether the camera
automatically sets the video output
resolution.
The default value is Disable.
Specifies the video output resolution for
the camera. This parameter is available
only when Set output resolution
automatically is set to Disable.
The default value is 1080p
60Hz.
Specifies whether the video input from
the camera is rotated by 180 degrees.
When the camera is hung, set this
parameter to Enable.
The default value is Disable.
----End
4.2.5 Switching Between Screen Layouts
By adjusting the screen layout, you can view multiple videos on the same display device.
Only the main output port supports combined picture output. For details, see Table 4-8 in
4.2.1 Configuring Video Output.
To adjust the screen layout, use either of the following methods:
When the endpoint is not in use in a conference, press on the remote control to
switch between the full screen, Picture in Picture (PiP) and two-pane (larger pane on the
left, larger pane on the top, or two panes in the same size) modes. When the endpoint is
in use in a conference, press on the remote control to switch between the full
screen, PiP, two-pane (larger pane on the left, larger pane on the top, or two panes in the
same size), and three-pane modes.
When the endpoint is in use in a conference, select from the option bar and select
a desired layout from the following:
− Remote video in full screen
− Local video in full screen
− Combination of the local video, remote video, local presentation, and remote
presentation in PiP, two-pane, or three-pane mode
To Next Page
Loading...
Need help?
General
