HUAWEI TE80 Videoconferencing Endpoint
Administrator Guide
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Specifies the local SIP listening port.
The default value is 5060.
Value range: 1-65534.
Specifies the listening port on the SIP
server with which your endpoint
registers.
The default value is 5060.
Value range: 1-65534.
Specifies the port use.
Normal: The number of the port
currently in use cannot be changed.
Port convergence: The port numbers
used in H.323 converge. Specifically,
signals of different formats use the
same port number. This saves port
resources.
Same port send/receive: Your
endpoint sends and receives data
streams through the same port.
The default value is Same port
send/receive.
Specifies the port your site uses to
receive audio packets during
communication with remote sites.
The default value is 10002.
Enter an even number ranging
from 1 to 65534.
Specifies the port your site uses to
receive video packets during
communication with remote sites.
The default value is 10004.
Enter an even number ranging
from 1 to 65534.
Specifies the port your site uses to send
SIP signaling during communication
with remote sites when Transmission
type is set to TLS.
The default value is 5061.
Value range: 1-65534.
NOTE
For details about how to set
Transmission type, see 3.1.4
Setting SIP Parameters.
Local SIP
TLS listen
port
Specifies the local SIP listening port
when Transmission type is set to TLS.
SIP server
TLS listen
port
Specifies the listening port on the SIP
server with which your endpoint
registers when Transmission type is set
to TLS.
Use TCP to
transmit
streams
Specifies whether to use the
Transmission Control Protocol (TCP) to
transmit video and data streams.
NOTE
If you set this parameter to Enable, you must
also set TCP listen port and TCP
connection port.
The default value is Disable.
Specifies the local listening port for TCP
streams.
The default value is 20002.
Value range: 1-65534.
To Next Page
Loading...
Need help?
General
