HUAWEI TE80 Videoconferencing Endpoint
Administrator Guide
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
this parameter. If you set Encryption
mode to NONE, the Wi-Fi network
provided by your endpoint is open to
everyone.
Specifies the password used by other
devices to connect to your endpoint.
The required password varies
depending on your settings of
Encryption mode.
If you set Encryption mode
toAES or TKIP, the default
value of the password is
Change_Me.
If you set Encryption mode
to WEP, the default value
of the password is
wifi_ap_wep_1.
If you set Encryption mode
to NONE, the Wi-Fi
network provided by your
endpoint is open to
everyone.
Local IP
address
Subnet mask
Specify the IP address and subnet mask
of your endpoint.
Default values:
Local IP address:
192.168.2.1
Subnet mask:
255.255.255.0
Specifies whether your endpoint assigns
IP addresses to devices connected to it.
NOTE
If you select this parameter, you must also set
Start IP address and End IP address.
This parameter is selected by
default.
Start IP
address
End IP
address
Specify the IP address segment for the
devices connected to your endpoint.
Default values:
Start IP address:
192.168.2.10
End IP address:
192.168.2.100
Step 3 Select Save.
In the Connected devices list box, you can view the MAC and IP addresses of all the devices
connected to your endpoint.
----End