LUNA2000-200KWH-2H1 Smart String ESS
User Manual
B Repainting the Equipment
Copyright © Huawei Technologies Co., Ltd.
paint the area.
4. The paint coating
should be thin
and even. The
surface should be
smooth. There
must not be any
paint drops on
the coating.
5. Leave the
repainted area for
about 30 minutes
before
performing any
further operation.
If a logo or pattern has been damaged,
obtain the logo size and color number and
contact a local advertisement coating
supplier to formulate a repair solution based
on the logo size, color, and damage.
1. If a dent is less than 100 mm
2
in area and
3 mm in depth, fill the dent with
Poly-Putty base and then perform the
same operations as those for fixing deep
scratches.
2. If a dent is greater than 100 mm
2
in area
or greater than 3 mm in depth, contact
the local supplier for an appropriate
repainting solution.
Procedure
Step 1 Gently polish the damaged areas using fine sandpaper to remove smudges or rust.
Figure B-1 Polishing a damaged area using sandpaper
Step 2 Dip a piece of cotton cloth into anhydrous alcohol and wipe the polished or damaged area to
remove dirt or dust. Then wipe off the alcohol with a clean and dry cotton cloth.
To Next Page
Loading...
