To avoid leakage, smoke, ammable gas release, thermal runaway, re, or
explosion, do not disassemble, alter, or damage batteries, for example, insert
foreign matter into batteries, squeeze batteries, or immerse batteries in water or
other liquids.
There is a risk of re or explosion if the model of the battery in use or used for
replacement is incorrect. Use a battery of the model recommended by the vendor.
Battery electrolyte is toxic and volatile. Do not get contact with leaked liquids or
gases in the case of battery leakage or emission of abnormal odor. In such cases,
stay away from the battery and contact professionals immediately. Professionals
shall wear safety goggles, rubber gloves, gas masks, and protective clothing,
power o the equipment, remove the battery, and contact technical engineers.
A battery is an enclosed system and will not release any gases under normal
operations. If a battery is used improperly, for example, burnt, needle-pricked,
squeezed, struck by lightning, overcharged, or subject to other adverse conditions
that may cause battery thermal runaway, the battery may be damaged or an
abnormal chemical reaction may occur inside the battery, resulting in electrolyte
leakage or release of gases such as CO and H
2
. To prevent re or equipment
corrosion, ensure that ammable gases are properly exhausted.
The gases generated by a burning battery may irritate your eyes, skin, and throat.
Take protective measures.
Install batteries in a dry area. Do not install them below areas prone to water
leakage, such as air conditioner vents, ventilation vents, feeder windows of the
equipment room, or water pipes. Ensure that no liquid enters the equipment to
prevent faults or short circuits.
SmartLi 3.0
User Manual (Short-Term Backup Power) 1 Safety Information
Issue 10 (2024-01-31) Copyright © Huawei Digital Power Technologies Co., Ltd. 5
To Next Page
Loading...
