Huawei SmartLi 3.0 - Optional) Imanager-M Service Access

6.3 (Optional) iManager-M Service Access
NO TICE
● If the 4G module has been installed, use the method described in the 4G
module access scenario (LCD or WebUI) to complete iManager-M service
access.
● If the device has been connected to the LAN switch or router, use the method
described in the FE access scenario (LCD or WebUI) to complete iManager-M
service access.
4G Module Access Scenario (LCD)
Step 1 Set iManager-M Service parameters.
On the LCD, choose System Info. > Settings > Settings Wizard. On the
iManager-M Service screen, set Enable/Disable to Enable and Access channel to
4G.
NO TE
If Access authentication code on the iManager-M Service screen is empty, obtain the
authentication code from the position shown in the following gure and enter it in Access
authentication code.
Figure 6-30 Documentation QR code on the cabinet
SmartLi 3.0
User Manual (Short-Term Backup Power) 6 Power-On and Commissioning
Issue 10 (2024-01-31) Copyright © Huawei Digital Power Technologies Co., Ltd. 131