Huawei SmartLi 3.0 - Page 141

Figure 6-31 About
(1) Authentication code
Step 2 Choose System Status > Runn. Info. > Wireless Module on the LCD. Conrm that
the 4G module dial-up is successful and check the signal strength.
Step 3 Connect the device on the NetEco app.
----End
4G Module Access Scenario (WebUI)
Step 1 Set wireless module parameters.
Choose Monitoring > Wireless Module > Running Parameter on the WebUI. Set
Mobile data to Enable and set operator parameters based on site requirements.
Step 2 Check the running status of the wireless module.
Choose Monitoring > Wireless Module > Running Information on the WebUI.
Check the 4G module running status, conrm that the 4G module dial-up is
successful, and check the signal strength.
NO TICE
If the dial-up connection fails, the possible causes are as follows:
● The SIM card is invalid. (The account is deregistered because it has been in
arrears for a long time.)
● Network signals are weak.
Step 3 Set and test domain name parameters.
1. Choose System Settings > NMS Application > BIN > Communication
Parameters on the WebUI. Set parameters as follows:
– Address type: Domain name
– Server domain name and Port number: Retain the default values.
– Connection test link setup port: 4G
2. Click Test Connect. After the test is successful, click Submit.
SmartLi 3.0
User Manual (Short-Term Backup Power) 6 Power-On and Commissioning
Issue 10 (2024-01-31) Copyright © Huawei Digital Power Technologies Co., Ltd. 132