Huawei SmartLi 3.0

To Next Page

To Previous Page

Step 4 Connect the device on the NetEco app.

----End

FE Access Scenario (LCD)

Step 1 Set iManager-M Service parameters and the IP addresses for the DNS server.

Choose System Status > Settings > Settings Wizard on the LCD. On the

iManager-M Service screen:

● Set Enable/Disable to Enable and Access channel to FE

● Set IP addresses for the DNS server based on site requirements.

Step 2 Set the IP address of the device.

Choose System Status > Settings > Settings Wizard on the LCD. On the

Network Param. page, set the IP address, subnet mask, and gateway based on

site requirements.

Step 3 Connect the device on the NetEco app.

----End

FE Access Scenario (WebUI)

Step 1 Set the IP address of the device.

Choose System Settings > Comm. Settings > IP Settings on the WebUI. Set IP

address type to IPv4, and set the IP address, subnet mask, and default gateway

based on site requirements.

Step 2 Set IP addresses for the DNS server.

Choose System Settings > Comm. Settings > DNS Server Address on the WebUI.

Set IP addresses for the DNS server based on site requirements.

Step 3 Set and test domain name parameters.

1. Choose System Settings > NMS Application > BIN > Communication

Parameters on the WebUI. Set parameters as follows:

– Address type: Domain name

– Server domain name and Port number: Retain the default values.

– Connection test link setup port: FE

2. Click Test Connect. After the test is successful, click Submit.

Step 4 Connect the device on the NetEco app.

----End

SmartLi 3.0

User Manual (Short-Term Backup Power) 6 Power-On and Commissioning

Huawei SmartLi 3.0 - Page 142