Huawei SmartLi 3.0 - Installing Optional Components; Installing a Carbon Monoxide Gas Sensor

Figure 5-47 Installing the BCU
Step 10 Select the corresponding model on the nameplate of the cabinet based on the
quantity of installed battery modules. (The gure uses 14 battery modules as an
example.)
Figure 5-48 Selecting a model
----End
5.8 Installing Optional Components
5.8.1 Installing a Carbon Monoxide Gas Sensor
Prerequisites
If a carbon monoxide gas sensor is congured, perform the following steps to
install it.
Procedure
Step 1 Install a carbon monoxide gas sensor.
1. Remove the support for the carbon monoxide gas sensor.
2. Keep the DIP switch of the carbon monoxide gas sensor facing upwards,
install the sensor on the support, and tighten the screws.
3. Reinstall the support together with the carbon monoxide gas sensor.
SmartLi 3.0
User Manual (Short-Term Backup Power) 5 Installation and Cable Connection
Issue 10 (2024-01-31) Copyright © Huawei Digital Power Technologies Co., Ltd. 95