Huawei SmartLi 3.0

To Next Page

To Previous Page

Figure 5-8 Drilling a hole and installing an expansion sleeve

(1) M12 bolt (2) Spring washer (3) Flat washer

(4) Expansion sleeve (5) Expansion nut (6) Concrete oor

Step 3 Wheel the cabinet to the installation position.

Step 4 If the castors need to hang in the air, perform 1 and 2 in Non-Secured

Installation.

Step 5 Secure the cabinet.

● Not against a wall

a. Remove the four plugs from the bottom of the cabinet.

b. Insert expansion bolts into the expansion bolt holes in the oor, and

tighten the expansion bolts.

Figure 5-9 Tightening expansion bolts (not installed against a wall)

● Against a wall

a. Remove the battery trays shown in the gure.

b. Remove the four plugs from the bottom of the cabinet.

c. Insert M12x115 expansion bolts into the expansion bolt holes in the oor

and tighten the expansion bolts.

SmartLi 3.0

User Manual (Short-Term Backup Power) 5 Installation and Cable Connection

Huawei SmartLi 3.0 - Page 77