Huawei USG6000E Series - Page 520

Figure 5-2 Installing the mounting ears on the chassis
NO TE
If the tray installation mode is used, skip this step.
Step 2 Install
oating nuts.
Figure 5-3 illustrates the positions of
oating nuts.
Figure 5-3 Positions of oating nuts
Use M6 screws to x the oating nuts at the positions specied in Figure 5-3, as
shown in Figure 5-4.
HUAWEI USG6000E Series
Hardware Guide 5 Hardware Installation
Issue 08 (2022-04-20) Copyright © Huawei Technologies Co., Ltd. 513