Huawei V100R006C00 - Example for Configuring Local Flow Mirroring

#
sysname Switch
#
vlan batch 10
#
observing-port 1 interface GigabitEthernet0/0/3
#
vlan 10
mac-mirroring 0001-0001-0001 to observe-port 1 inbound
#
interface GigabitEthernet0/0/1
port link-type trunk
port trunk allow-pass vlan 10
#
interface GigabitEthernet0/0/2
port link-type trunk
port trunk allow-pass vlan 10
#
interface GigabitEthernet0/0/3
port link-type trunk
port trunk allow-pass vlan 10
#
interface GigabitEthernet0/0/4
port link-type trunk
port trunk allow-pass vlan 10
#
#
return
7.17.4 Example for Configuring Local Flow Mirroring
Networking Requirements
As is shown in Figure 7-7, the Switch is connected to two L2 switches through
GigabitEthernet 0/0/1 and GigabitEthernet 0/0/5. Packets with the same attributes received by
GigabitEthernet 0/0/1 and GigabitEthernet 0/0/5 and transmitted from GigabitEthernet 0/0/3
need to be monitored. In this example, packets with the 802.1p priority as 6 need to be monitored.
GigabitEthernet 0/0/24 is configured as an observing port.
Quidway S5700 Series Ethernet Switches
Configuration Guide - Device Management 7 Mirroring
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
102