Huawei V100R006C00 - 5.4 Configuring Electrical Port Sleep

No. Data
3 FTP server address, FTP user name, and password (only applicable to saving the
electronic label to an FTP server)
5.3.2 Backing Up the Electronic Label
You can back up the electronic label of the S5700 to an FTP server or the CF card of the
S5700.
Procedure
l Back up the electronic label to the CF card.
1. Run the following command in the user view:
backup elabel [ slot slot-id ]
The electronic label is backed up to the CF card.
l Back up the electronic label to an FTP server.
1. Run the following command in the user view:
backup elabel [ ftp ip-address filename username password ] [ slot slot-
id [ subcard-id ] ]
The electronic label is backed up to an FTP server.
----End
5.4 Configuring Electrical Port Sleep
This section describes how to configure electrical port sleep to save energy.
5.4.1 Establishing the Configuration Task
Before configuring electrical port sleep, familiarize yourself with the applicable environment,
complete the pre-configuration tasks, and obtain the required data. This helps you complete the
configuration task quickly and accurately.
Applicable Environment
When a device is working normally, you can enable electrical port sleep to save energy.
Pre-configuration Tasks
None.
Data Preparation
To configure electrical port sleep, you need the following data.
Quidway S5700 Series Ethernet Switches
Configuration Guide - Device Management 5 Hardware Management
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
46