vlan vlan-id
An RSPAN VLAN is created and the RSPAN VLAN view is displayed.
3. Run:
mac-address learning disable
The MAC address learning is disabled.
NOTE
If MAC address learning is disabled in the VLAN, other services cannot be configured in the VLAN.
4. Run:
quit
Return to the system view.
5. Run:
observe-port index interface interface-type interface-number [ vlan vlan-
id ]
An observing port is configured, and the RSPAN VLAN is specified.
6. Run:
traffic behavior behavior-name
A traffic behavior is created and the traffic behavior view is displayed.
7. Run:
mirroring to observe-port index
Remote flow mirroring is configured.
After configuring flow mirroring in a traffic behavior, you need to bind the behavior
to a traffic classifier in a traffic policy and then apply the policy to the interface. For
details, see 7.11.4 Creating and Applying a Traffic Policy.
l Configure the RSPAN VLAN on the intermediate switch and add interfaces to the RSPAN
VLAN.
The configuration is the same as that for remote port mirroring. For details, see 7.3.2
Configuring Remote Port Mirroring.
l Configure the remote observing Interface on the destination switch.
The configuration is the same as that for remote port mirroring. For details, see 7.3.2
Configuring Remote Port Mirroring.
----End
7.12.4 Creating and Applying a Traffic Policy
Context
For how to configure traffic classification rules on the source S5700, see 7.11.4 Creating and
Applying a Traffic Policy.
7.12.5 Checking the Configuration
Run the following commands to check the previous configuration.
Quidway S5700 Series Ethernet Switches
Configuration Guide - Device Management 7 Mirroring
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
89
To Next Page
Loading...
