Huawei V100R006C00 - 7.7 Canceling VLAN Mirroring

The configuration is the same as that for remote port mirroring. For details, see 7.3.2
Configuring Remote Port Mirroring.
----End
7.6.3 Checking the Configuration
Run the following commands to check the previous configuration.
Action Command
Check information about the
observing port.
display observe-port
Check information about port
mirroring.
display port-mirroring
If the following results are obtained, the configuration is successful:
l The type of the observing port is configured properly.
l The number of the observing port is configured properly.
7.7 Canceling VLAN Mirroring
This section describes how to cancel local VLAN mirroring and remote VLAN mirroring.
7.7.1 Establishing the Configuration Task
Applicable Environment
When VLAN mirroring is enabled in a specified VLAN and all incoming packets in this VLAN
do not need to be monitored on the S5700, or before deleting or changing the bound observing
port, you need to cancel VLAN mirroring.
Pre-configuration Tasks
None.
Data Preparation
To cancel VLAN mirroring, you need the following data.
No.
Data
1 ID of the mirrored VLAN to be deleted
7.7.2 Canceling VLAN Mirroring
Quidway S5700 Series Ethernet Switches
Configuration Guide - Device Management 7 Mirroring
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
79