Huawei V100R006C00 - 7.11 Configuring Local Flow Mirroring

7.10.3 Checking the Configuration
Run the following commands to check the previous configuration.
Action Command
Check information about the
observing port.
display observe-port
Check the configuration of the
mirrored port.
display port-mirroring
If MAC address mirroring on the VLANIF interface is cancelled, the configuration is successful.
7.11 Configuring Local Flow Mirroring
This section describes how to configure local flow mirroring.
7.11.1 Establishing the Configuration Task
Applicable Environment
When incoming flows passing through the S5700 with the same attribute need to be monitored,
you can configure local flow mirroring if the monitored interface receiving these incoming flows
is located on the same S5700 as the observing port.
Pre-configuration Tasks
None.
Data Preparation
To configure local flow mirroring, you need the following data.
No.
Data
1 Type and number of the observing port
2 Type and number of the flow mirroring interface
3 Names of the traffic classifier, traffic behavior, and traffic policy
7.11.2 Configuring Traffic Classification Rules
NOTE
There is no specified order among the matching rules in a traffic classifier. You can combine these rules.
For details on configuring traffic classification rules, see Configuring Complex Traffic
Classification in the Quidway S5700 Series Ethernet Switches Configuration Guide - QoS.
Quidway S5700 Series Ethernet Switches
Configuration Guide - Device Management 7 Mirroring
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
85