Huawei V100R006C00 - Optional) Enabling the Stacking Function; Optional) Configuring a Stack ID for the S5700

The reserved VLAN of the stack is configured on the master switch.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
stack reserved-vlan vlan-id
The reserved VLAN is configured.
By default, a stack system uses VLAN 4093 as the reserved VLAN.
NOTE
The reserved VLAN cannot be used for other services.
----End
3.5.3 (Optional) Enabling the Stacking Function
Context
Before connecting stack devices through leased stack cables, do as follows on the stacking-
capable devices.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
stack enable
The stacking function is enabled on the S5700.
By default, the stacking function is enabled.
NOTE
If you run the undo stack enable command to disable the stacking function on the S5700, the configuration
takes effect only after the S5700 is restarted. If you run the stack enable command to enable the stacking
function on the S5700, the configuration takes effect only after the S5700 is restarted.
----End
3.5.4 (Optional) Configuring a Stack ID for the S5700
Context
Stack IDs can be configured before or after the stack system is created. By default, stack IDs of
member switches in a stack are all 0s. If stack IDs are not configured for member switches before
the stack system is created, the stack system assigns stack IDs to member switches after being
Quidway S5700 Series Ethernet Switches
Configuration Guide - Device Management 3 Stacking
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
34