4.1 Introduction
This section describes function of display commands.
You can use display commands to view the status of a device and check whether the device runs
normally.
4.2 Checking the Status of the S5700
This section describes how to check the status of the S5700 by using the display commands.
4.2.1 Checking Information About the S5700
Context
You can run the following command in any view to check the type and status of a component
on the S5700.
Procedure
Step 1 Run:
display device [ slot slot-id ]
Information about a component on the S5700 is displayed.
----End
4.2.2 Checking the Version of the S5700
Context
You can run the display version command in any view to check the version of the S5700.
The displayed information includes the type of a card, startup duration, version of the hardware,
and version of the software.
Procedure
Step 1 Run:
display version [ slot slot-id ]
The version of the specified card is displayed.
----End
4.2.3 Checking the Electronic Labels
Context
You can run the display elabel command in any view to check the electronic labels.
Quidway S5700 Series Ethernet Switches
Configuration Guide - Device Management 4 Using display commands to check the status of the device
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
40
To Next Page
Loading...
