CAUTION
Statistics cannot be restored after being cleared. So, confirm the action before you run the
command.
Action Command
Clear the statistics in the
information center.
reset info-center statistics
Clear the information in the log
buffer.
reset logbuffer
Clear the information in the trap
buffer.
reset trapbuffer
6.5 Configuration Examples
This section provides examples for configuring the information center.
6.5.1 Example for Configuring the Information Center
Networking Requirements
Figure 6-4 Networking of sending logs to the log host
Network
Log Host
Switch
1.0.0.1/8
VLANIF10
2.0.0.1/8
Configuration Roadmap
The configuration roadmap is as follows:
1. Enable the information center.
2. Configure the information channel to ensure that the S5700 can correctly send logs to the
log host. Disable the sending of the traps and debugging information to the log host.
3. Configure the log host.
Data Preparation
To complete the configuration, you need the following data:
Quidway S5700 Series Ethernet Switches
Configuration Guide - Device Management 6 Monitoring the Device Through the Information Center
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
61
To Next Page
Loading...
