Huawei V100R006C00 - Example for Changing an Observing Port

interface GigabitEthernet0/0/1
port link-type trunk
port trunk allow-pass vlan 2
#
interface GigabitEthernet0/0/2
port link-type trunk
port trunk allow-pass vlan 2
#
#
return
Configuration file of Switch C
#
sysname SwitchC
#
vlan 2
#
interface GigabitEthernet0/0/1
port hybrid untagged vlan 2
#
interface GigabitEthernet0/0/2
port link-type trunk
port trunk allow-pass vlan 2
#
#
return
7.17.6 Example for Changing an Observing Port
Networking Requirements
As shown in Figure 7-9,GigabitEthernet 0/0/1 on the Switch is connected to an L2 switch;
GigabitEthernet 0/0/24 is connected to host 1; GigabitEthernet 0/0/5 is connected to host 2. To
monitor incoming traffic on GigabitEthernet 0/0/1, port mirroring is configured on the Switch.
Configure GigabitEthernet 0/0/1 as a mirrored port, and GigabitEthernet 0/0/24 connected to
host 1 as an observing port. Enable host 1 to receive incoming traffic from GigabitEthernet 0/0/1.
At present, host 2 needs to receive incoming traffic from GigabitEthernet 0/0/1. Therefore, the
observing port needs to switch from GigabitEthernet 0/0/24 to GigabitEthernet 0/0/5.
Quidway S5700 Series Ethernet Switches
Configuration Guide - Device Management 7 Mirroring
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
108