Huawei V100R006C00 - Page 118

Figure 7-9 Networking for changing the observing port
Router
Switch
GE0/0/3
GE0/0/1
L2 Switch
Mirroring
host1
Mirroring
host2
GE0/0/5
GE0/0/24
Configuration Roadmap
The configuration roadmap is as follows:
1. Delete the mirrored port GigabitEthernet 0/0/1.
2. Set GigabitEthernet 0/0/5 instead of GigabitEthernet 0/0/24 as the observing port.
3. Reset GigabitEthernet 0/0/1 as a mirrored port.
Data Preparation
To complete the configuration, you need the following data:
l Type and number of the new observing port, that is, GigabitEthernet 0/0/5
Configuration Procedure
1. Check the configurations on the current observing port and mirrored port.
# Run the display port-mirroring command to check the configurations on the current
observing port and mirrored port.
<Switch> display port-mirroring
Port-
mirror:
----------------------------------------------------------
Mirror-port Direction Observe-port
----------------------------------------------------------
GigabitEthernet0/0/1 Inbound
GigabitEthernet0/0/24
2. Delete the mirrored port.
# Delete the mirrored port GigabitEthernet 0/0/1.
<Switch> system-view
[Switch] interface GigabitEthernet 0/0/1
[Switch-GigabitEthernet0/0/1] undo port-mirroring inbound
Quidway S5700 Series Ethernet Switches
Configuration Guide - Device Management 7 Mirroring
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
109