Huawei V100R006C00 - Page 119

3. Delete the observing port.
# Delete the observing port GigabitEthernet 0/0/24.
<Switch> system-view
[Switch] undo observe-port 1
4. Change the observing port.
# Change the observing port to GigabitEthernet 0/0/5.
[Switch] observe-port 1 interface GigabitEthernet 0/0/5
5. Configure a mirrored port.
# Configure GigabitEthernet 0/0/1 as the mirrored port again.
[Switch] interface GigabitEthernet 0/0/1
[Switch-GigabitEthernet0/0/1] port-mirroring to observe-port 1 inbound
[Switch-GigabitEthernet0/0/1] quit
6. Verify the configuration.
# Run the display port-mirroring command. You can check the configurations on the
current observing port and mirrored port.
[Switch] display port-mirroring
Port-
mirror:
----------------------------------------------------------
Mirror-port Direction Observe-port
----------------------------------------------------------
GigabitEthernet0/0/1 Inbound
GigabitEthernet0/0/5
Configuration Files
Configuration file of the Switch
#
sysname Switch
#
observe-port 1 interface GigabitEthernet0/0/5
#
interface GigabitEthernet0/0/1
port-mirroring to observe-port 1 inbound
#
return
Quidway S5700 Series Ethernet Switches
Configuration Guide - Device Management 7 Mirroring
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
110