Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
vlan vlan-id
The view of the monitored VLAN is displayed.
Step 3 Run:
undo mirroring inbound
VLAN mirroring is canceled.
----End
7.7.3 Checking the Configuration
Run the following commands to check the previous configuration.
Action Command
Check information about the
observing port.
display observe-port
Check information about port
mirroring.
display port-mirroring
If VLAN mirroring is cancelled, the configuration is successful.
7.8 Configuring MAC Address-based Local Mirroring
This section describes how to configure local MAC address mirroring.
7.8.1 Establishing the Configuration Task
Applicable Environment
When incoming packets with the specified source or destination MAC address in a VLAN need
to be monitored on the S5700, you can configure local MAC address mirroring if the monitoring
interface receiving these incoming packets is located on the same S5700 as the observing port.
Pre-configuration Tasks
None.
Data Preparation
To configure local MAC address mirroring, you need the following data.
Quidway S5700 Series Ethernet Switches
Configuration Guide - Device Management 7 Mirroring
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
80
To Next Page
Loading...
