English – 15
Combi 112 and Combi 122
This machine is supplied with the Combi 112 or
Combi 122 cutting deck.
.
Hydraulic deck lift.
The cutting deck is raised and lowered with a
hydraulic cylinder. This acts on a rotating shaft.
When the shaft is rotated, the chain attached to a
segment inside the end of the shaft will raise or
lower the equipment frame.
Pushing up the PTO button acts on a solenoid clutch
that enables the blades to rotate. Blade rotation is
shut down by just pressing the PTO button.
The cutting height is adjusted using the lever that is
attached to the shaft with a joint and a spring. The
lever can be put in 6 xed positions plus one service
position.
See “5.7.7 Adjusting the cutting height range” on
page 82 for adjusting the cutting height.
4.6 Cutting deck
The machine can be tted with the Combi 112 and
Combi 122 cutting decks.
The Combi-unit, equipped with a BioClip-plug, nely
chops the cuttings to fertilizer. Without the BioClip-
plug the unit works in the same way as a rear
ejection unit. The rear ejector ejects the clippings
behind the unit without nely chopping them.
Design and Function
To Next Page
Loading...
