English – 83
5.7.8 Changing height adjustment cable
Dismantling
1. Remove the cutting deck. For further
instructions, refer to section “5.7.2 Cutting
deck” on page 78.
2. Release the lifting chain from the tool frame.
3. Dismantle the protecting cover on the tool
frame.
4. Remove the pulley and the cable retainer.
5. Loosen the locknuts on the cable sheath.
6. Pull back the rubber protection so that the cable
can pass through the bracket opening.
7. Take the cable out of the rubber strap.
8. Remove the right side cover.
9. Loosen the front snap lock on the cable.
10. Pull back the rubber protection so that the
cable can pass through the bracket opening.
Loosen the locknut and take the cable out
through the bracket.
Tools Dimension
Combination wrench x2 13 mm
Combination wrench x2 17 mm
Torx T30
Cutting system
To Next Page
Loading...
